On-Site Test Kit for Total Halogens in Used (Waste) oil
CLOR-D-TECT 1000 provides a "go, no-go" result at a level of 1000 ppm chlorine. Used oil transporters, generators and facilities that recycle or re-refine used oil can incorporate Clor-D-Tect 1000 into their management of waste oil to prevent costly hazardous waste from being mixed with non-contaminated oil. Generators can identify and label their waste oil, hazardous or non-hazardous, for proper management and disposal.
Designed for use on-site, the test takes less than 5 minutes to run with no special training. Each kit comes complete to perform one test, and all premeasured reagents are sealed in glass ampules. Clor-D-Tect 1000 has proven to be an ideal test to spot-check oil before it is transported, accepted or introduced into larger holding tanks.
Clor-D-Tect 1000 has been assigned ASTM Method D-5384 and USEPA SW-846 Method 9077.
|Analytes||Chlorine, Chlorinated Organics|
|Matrix||Used Oil, Solvents, Organic Liquids|
|Detection Method||Fixed endpoint colorimetric titration|
|Action Levels||Above or below the 1000 ppm regulatory limit|
|Interferences||Sulfur may cause false positive results|
|Analysis Time||Less than 5 minutes|
|Packaging||20 Kits to a shelf pack, 80 kits per case. Minimum order 10 kits. Orders greater than 10 kits must be in multiples of 20.|